Washers - wide 18mm(5mm internal)x1mm ( I will use them all over the place so get at least 50)
Bolts - any head 20mmx4mm will do ( again take at least 20 )
Brackets - 40mmx40mm right angle for wood frame
Held in place by zip ties.
You can get a dedicated power supply and depending on your motors choose a higher rated Amps.
Rule is generally add your stepper driver limit +5%~10%. No point in wasting money on more power than that.
In my case I will limit the Amps via the stepper drivers to collectively 2A and it will not be even at 25% duty cycle (calculating from 8sec exposure and 2sec tilting cycle).
I liked your article is an interesting technology
ReplyDeletethanks to google I found you
When using a switching power supply with stepper motors you should add a filter cap before the stepper motors, somewhere around 10000uf ought to be fine.
ReplyDeleteCorrect, but since we are talking a max draw of 1 A, 10000uf is overkill. Usually it is 200uf for every Amp of draw. If I have power problems I'll post and will use a 470uf capacitor.
ReplyDeleteThanks for the suggestion!